text.skipToContent text.skipToNavigation

How to access the Linksys WES610N v2 Media Connector’s web-based setup page manually

Learning how to access the web-based setup page of your Linksys WES610N v2 Media Connector is important especially if you want to configure its settings.  Changing basic settings or wireless security for your network and forwarding ports are just some of the most common configuration done on the web-based setup page.

To learn how you can manually access the web-based setup page of your WES610N v2 Media Connector, follow the steps below:

NOTE:  This article assumes that your computer is already connected to the WES610N v2 Media Connector using an Ethernet cable.

Step 1:
Launch a web browser such as Internet Explorer.

Step 2:
In the Address bar, enter your media connector’s IP address then press [Enter].

NOTE:  The media connector’s default IP address is 10.100.1.1. If it doesn’t work or if the IP address has been changed, check your Linksys router's DHCP Client Table for the media connector’s IP address.  For instructions, click here.

Step 3:
Enter your media connector’s User Name and Password then click OK.

NOTE:  The default password is admin and the User Name field is left blank.  If the login credentials have been personalized before, you may enter those instead.

You should have successfully accessed the web-based setup page of your Linksys WES610N v2 Media Connector now.


Related Article:

How to set up the Linksys WES610N v2 Media Connector manually

Was this support article useful?

Additional Support Questions?

Search Again

CONTACT SUPPORT