Setting up SSIDs and security on the Linksys Wireless-N Access Points with PoE, LAPN300 and LAPN600

The Linksys Wireless-N Access Points with PoE, LAPN300 and LAPN600 will allow you to set up as much as eight (8) SSIDs and configure wireless security settings for each. 
 
This article will guide you on how to set up SSIDs and configure wireless security settings for each of them.  Follow the steps below to learn how:
 
Step 1:
Access the web-based setup page of your access point.  For detailed instructions, click here.
 
Step 2:
Click Configuration.
 

Step 3:
Click Wireless > Basic Settings on the left-hand side.
 

Step 4:
Select your preferred Wireless Radio.  Radio 1 refers to the 2.4 GHz frequency while Radio 2 is for 5 GHz.  Make sure the Enable Radio box is checked then set up your preferred Network Mode and Wireless Channel.
 
NOTE:  If you are using the LAPN300, the Select Your Radio option is not available since LAPN300 is a single band access point.
 

Step 5:
Set up as much as eight (8) SSIDs then click Save.
 

Step 6:
Click Security on the left-hand side.
 

Step 7:
Click the drop-down arrow and select the SSID that you have previously set up to start configuring its security settings.
 

Step 8:
Configure your preferred security settings then click Save.  Repeat the step for each SSID you had set up.
 


 

Was this support article useful?

Additional Support Questions?
Search Again