Configuring the port lights of a Linksys Smart Wi-Fi Router using the Classic Firmware

The port lights of a Linksys Smart Wi-Fi Router can now be managed under the Setup tab of its web-based setup page.  Follow the steps below if you want to see the port lights lighting up or if you want them disabled.

IMPORTANT:  Before you proceed with configuring the port lights of your Linksys Smart Wi-Fi Router, make sure that your cables are properly connected.

Step 1:
Go to the router’s web-based setup page.  For instructions on how to do this, click here.  If you’re using a Mac computer, click here.

Step 2:
Under the Setup tab, scroll down and locate Port Lights.

Step 3:
Select On if you want to enable the router’s ports lights, or click Off to disable.

Step 4:
Click  to apply the changes.

The port lights of your router should now be enabled or disabled.

NOTE:  If you are using a Linksys Smart Wi-Fi Router, you can configure the port lights using your Linksys Smart Wi-Fi Account.  Just click the Connectivity Tool and select ON to enable the router’s port lights or click OFF to disable it.

Related Article:

Turning the Rear Port Lights OFF on a Linksys Wireless-N Router


Was this support article useful?

Additional Support Questions?
Search Again