text.skipToContent text.skipToNavigation

The Linksys WET11 and network ready printers

Yes you can, please follow these instructions:

  1. Configure your Access Point, through your wireless network, as you would normally.
  2. Connect the WET11 to your PC and configure it to communicate with your Access Point. Please be sure to set WET11 to the same SSID as your Access Point.
  3. After setting up the WET11 in step 2, you’ll need to connect it to your PRINTER, before you connect the unit, please make sure the WET11 is not powered up.
  4. Using the Ethernet Network cable included with the WET11, connect one end of the cable to the WET11 and the other to the Printers Ethernet port. Make sure the switch on the back of the WET11 is set to the X(crossover) setting.
  5. After completing step 4, power up the unit. After the unit has powered up, verify that the WLAN light is lit. The LAN Link light will not illuminate until after an online connection has been established.

Was this support article useful?

Additional Support Questions?

Search Again

CONTACT SUPPORT