text.skipToContent text.skipToNavigation

Connecting to the Wireless Network Using a Wireless-B Game Adapter

To connect the Wireless-B game adapter to a wireless network please determine your SSID and Wireless Security and/or Network Key. If you do not know your wireless settings and you’re using a Linksys router, click  here. If not, consult the user guide or the manufacturer of your router for assistance.

Setting-Up the Wireless-B Game Adapter

Step 1:
Connect the game adapter to your router using an Ethernet cable. For instructions, click  here.

Step 2:
Insert the Setup CD to your CD-ROM drive and run the Setup Wizard. A screen similar to Step 3 should appear.

Step 3:
Click Setup to begin the set up process.

Step 4:
The Setup Wizard will then search for the game adapter. If it cannot detect the presence of the game adapter, check the connections then click Continue.

Step 5:
When the next screen shows the current settings of the game adapter, click Next to continue.

NOTE: The IP Address is the current IP address of the game adapter. This will be helpful if you want to check the connection between the router and the game adapter.

Step 6:
When the game adapter is located, enter “admin” on the Password field and click Enter.

Step 7:
Make sure Obtain IP Address automatically is selected then, click Next.

Step 8:
Under Mode, select Internet then enter your wireless network’s SSID on the SSIDfield.

Step 9:
Select the correct encryption set on the wireless network.

If WEP is set to Disabled, it means there’s no security enabled on the wireless network. Click No and proceed to Step 11 for the next instruction.

If WEP is enabled, select the same WEP encryption level either 64 bit or 128 bit.

NOTE: In this example 128 bit was selected.

Step 10:
Enter a unique word under Passphrase or manually enter a WEP key and leave the Passphrase option blank. In this example “MySecretKey” is used as the Passphrase. You may click No to finish the configuration or Yes if you want to configure another profile.

NOTE: In this example, No was selected.

Step 11:
Click Exit to exit the Setup Wizard. You are now done configuring the game adapter.

Was this support article useful?

Additional Support Questions?

Search Again