text.skipToContent text.skipToNavigation

Getting to know the WML11B

Front Panel

You can control the Media Link through the front panel buttons and LCD screen, which you can also control using the Remote Controller. The arrow buttons enable you to navigate through the LCD menus.

Image





 Image      (Up and Down)

To the left of the LCD screen, the up and down arrow buttons allow you to scroll through a menu. While music is playing, they also act as volume control buttons.

Image   (Play/Pause)

To the right of the LCD screen, the left arrow/pause button allows you to play or to pause a music track.

Image   (Stop)

The square button stops the playing of the selected music track.

Image    (Left and Right)

The left arrow button allows you to cancel a selection or move back through the menus. The right arrow button allows you to make a selection or move forward through the menus.

Image      (Power)

The power button allows you to power on and off the Media Link.



Back Panel

On the Media Link's back panel, there is an inset that features six ports, a crossover (X-II) switch, and a Reset button.

Image



  Image     POWER

The Power port is where you will connect the Media Link's power adapter. 

  Image     SPEAKER DC 

The Speaker DC port is where you will connect the speaker power cord (WMLS11B only).

NOTE: The only speaker you should connect to the Speaker DC port is the right speaker  included with the Wireless-B Music System (WMLS11B). Do not connect your own powered speakers to the Media Link's Speaker DC port; otherwise, the Media Link and your powered speakers may be severely damaged.

  

  Image CROSSOVER

The Crossover (X-II) switch is used only when the Media Link is connected to a wired network device. If the Media Link is connected to a PC, then the switch should be in the Crossover (X) position. If the Media Link is connected to a router or switch, then the switch should be in the Parallel (II) position.

Image   ETHERNET

The Ethernet port is where you will connect the Ethernet network cable.

Image     DIGITAL OUTPUT

The Digital Output port is where you will connect the optical cable.

Image    2 CH OUTPUT

The 2 CH Output ports are where you will connect the left and right RCA audio cables. 

  Image      RESET

The Reset button is what you will push if you need to reset the Media Link.





Was this support article useful?

Additional Support Questions?

Search Again

CONTACT SUPPORT