How to install the Linksys Velop Wall Mount

The Linksys Velop Wall Mount lets you mount your Velop node on the wall, allowing you to save shelf space and obtain better Wi-Fi coverage.  This article provides step-by-step instructions on how to properly install your Velop Wall Mount.

Before you begin, consider the following:
  • Make sure that there is an electrical outlet within the range from where you want to install your wall mount.
  • The kit comes with two interchangeable mounting caps for the Linksys Velop Tri-Band and Velop Dual-Band (Models: WHW03, WHW01, VLP01).  Choose the correct mount cap for your Velop.
User-added imageUser-added image
WHW03 mounting capWHW01 / VLP01 mounting cap
Step 1:
Insert the mounting cap into the wall mount.

User-added image
Step 2:
Secure the mounting cap to the base using one screw to the lower middle portion of the bracket.

User-added image
 
Step 3:
On the wall, use the rest of the screws and anchors to hold the mount in place.

User-added image
IMPORTANT:  After you have mounted the wall mount, see to it that it is secure.​
 
Step 4:
Run the power cable through the wall mount and connect it to your node.  You can also coil the power cable inside the mount.

User-added image
WHW03 

User-added image
WHW01 / VLP01

Step 5:
Insert the node into the mount.
 
User-added image
 
You have now successfully installed your wall mount.


Related Articles:

Getting to know the Linksys Velop Wall Mount
Linksys Velop Wall Mount Frequently Asked Questions

Was this support article useful?

Additional Support Questions?
Search Again