Configuring the Workgroup Bridge on the Linksys Wireless-N300 and N600 Access Points with PoE

This article will guide you on how to configure the Workgroup Bridge on the Linksys Wireless-N300 and N600 Access Points with PoE (LAPN300 LAPN600).  Follow the steps below to learn how:
 
Step 1:
Access the web-based setup page of the Linksys Wireless-N Access Point with PoE.  For detailed instructions, click here.
 
Step 2:
Click the Configuration tab.
 

Step 3:
Click Wireless on the left hand sidebar then click Workgroup Bridge.
 

Step 4:
Check the Enable box then click the Site Survey button.
 

Step 5:
Select your preferred SSID on the pop-up window.

Step 6:
Your chosen SSID will then appear in the SSID field.  Configure your security settings then click the Save button.  The Connection Status will then display “Connected” after establishing a successful connection.
 

 
You have now configured Workgroup Bridge on your Wireless-N300 and N600 Access Points with PoE.


 

Was this support article useful?

Additional Support Questions?
Search Again