You will still have to set up the additional nodes wirelessly using the Linksys app; once this is done, connect the nodes using CAT5e or higher-rated ethernet cables and the nodes should automatically switch to a wired connection.
Set up the parent node using the Linksys app (if not yet set up). Click each link below for specific instructions:
Add the child node using the Linksys app. Click each link below for specific instructions:
Connect an ethernet cable to the child node and connect the other end of the cable to the parent node. The nodes will automatically switch to a wired connection.
For StarHub ISP, it is required to connect the child node from its WAN port to the LAN port of the parent node. This is for you to be able to stream with your StarHub Set-Top Box (TV+ Box) via the child node.
For non-Starhub nodes and other nodes with multiple ports, you can connect either from the WAN or LAN port of the child node to the LAN port of the parent node.
If you have other nodes to add, repeat Steps 2-3 but connect the additional child nodes to the upstream node instead of connecting them to the parent node.
You have now set up a wired mesh system. Keep in mind that the nodes need to be plugged into a power source. They do not provide power over ethernet (non-PoE); however, they can use managed or unmanaged switches. To learn more, click here.
Setting up the parent node using a static WAN IP address
Velop (WHW0301, WHW0302, WHW0303) User Guide
Linksys Velop Intelligent Mesh WiFi System, Dual-Band Frequently Asked Questions
Linksys Intelligent Mesh simple setup using a web browser
Setting up your first node using a PPPoE connection (VIDEO)
Setting up the first node of your Velop system using an Android™ device (VIDEO)
Adding a node to your Velop system (VIDEO)
How to log in to the Linksys Velop's web interface (VIDEO)
How do I identify which node is the Child node connected to (VIDEO)
Configuring the DNS Settings of your Velop network (VIDEO)