Setting up the Linksys E9450 as a Non-Mesh System

This article will show you how to set up your Linksys E9450 WiFi 6 Router as a Non-Mesh System.  If you have only one Linksys E9450 and would rather not use a Mesh system, follow the steps below.

NOTE:  This article is for Linksys E9450-AH, Linksys E9450-CN, Linksys E9450-JP, and Linksys E9450-KR.  In a Non-Mesh System, you will not be able to add child nodes.
 
Step 1:
Set up your router using the browser-based setup wizard.  For instructions, click here
.  If your router is already set up, go to Step 2.

Step 2:
After your router is set up, launch a web browser, enter “192.168.79.1” or “linksysxxxxx” where xxxxx is the last five characters of the serial number in the Address bar, and hit [ENTER].


Step 3:
Enter "admin" as the username and enter your password, then click Apply

NOTE:  The default Username and Password is admin.


Step 4:
Go to General > Mesh Setup and select Non-Mesh System.
 
User-added image

Step 5:
Click Apply/Save.

Was this support article useful?

Additional Support Questions?
Search Again