text.skipToContent text.skipToNavigation

Overview of the Wi-Fi Settings feature on the Linksys app for Velop

User-added image

This article provides an overview of the Wi-Fi Settings feature on the Linksys app for Velop.

NOTE: The settings can be configured by tapping on the Menu icon and selecting Wi-Fi Settings.

User-added image


Wi-Fi Name and Wi-Fi Password
Displays your Wi-Fi credentials. Tap each field to make changes.
Advanced Wi-Fi Settings

User-added image

Security Type

Tap this option to make changes to your security settings. The options are WPA2/WPA Mixed Personal, WPA2 Personal, or Open. The default security type (WPA2™ Personal) is recommended.

Wi-Fi Mode

Mixed mode is the only supported option.

Channel Finder

Velop automatically selects the best channel to resolve congestion and interference with other Wi-Fi signals through this feature.

Wi-Fi signals are broadcast on multiple channels. The Channel Finder will investigate each node in your Velop system to find the channel with the least amount of traffic.

User-added image

NOTE: All devices will be disconnected temporarily during the scan.

If better channels are found, the Channel Finder will make the changes for you.

User-added image

However, if you are already using the best channels, the following message will display:

User-added image

If your Wi-Fi channels were optimized, you can tap on Technical details to view the new channels.

For example, on the Office node, the 2.4 GHz radio went from Channel 2 to Channel 11 and its 5 GHz radio did not change. It automatically determines which channels to change based on your environment’s Received Signal Strength Indicator (RSSI).

User-added image

If your Wi-Fi channels were not optimized, it will instead display Channel Details similar to the one below:

User-added image
Connect a Device with WPS
Wi-Fi Protected Setup™ (WPS) allows you to easily connect WPS-supported devices to your Wi-Fi without manually configuring security settings. To access this feature, go to Wi-Fi Settings > Connect a Device With WPS and toggle the switch OFF or ON to disable or enable it.

To add a device, tap on Connect. You have 2 minutes to push the WPS button on your device to connect it to your Wi-Fi. To connect using a PIN or if your device asks for a router WPS PIN, tap Use a PIN. WPS is configured via the Linksys app. There is no external button on the node itself.

User-added image