text.skipToContent text.skipToNavigation

[Singapore] How to replace the StarHub Bundled Wireless Router with the Linksys WRT1900AC

This article will show you the procedure on how to replace the StarHub Wireless Bundled Router with the Linksys WRT1900AC. 
 
IMPORTANT:  Make sure that your Linksys WRT1900AC is updated with the latest firmware version first before replacing the bundled wireless router of your fiber ISP.  For instructions on how to upgrade the firmware of your router, click here.
 
Step 1:
Connect your computer directly to one of the LAN ports (1-4) of your Linksys WRT1900AC router.
 
 
 
Step 2:
Launch a web browser then enter “http://192.168.1.1” or “http://myrouter.local” on the Address bar then press [Enter].
 
 
 
Step 3:
On the Sign In page, enter “admin” as the default password then click Sign In.
 
 
 
Step 4:
Under Router Settings, click Connectivity.

 
 
 
Step 5:
Click VLAN.
 
 
 
Step 6:
On the VLAN page, switch VLAN to ON.
 
 
Step 7:
Under Select Profile, click the drop-down button and select StarHub if you are using the StarHub fiber line.
 
 
Step 8:
Click  then click .
 
Step 9:
Go back to Router Settings > Connectivity then click the Internet Settings tab.
 
 
Step 10:
Under Internet Settings, enable MAC Address Clone then enter the MAC address of the StarHub bundled wireless router.  Click Apply and Ok
 
QUICK TIP:  The MAC address is MTA MAC found on the sticker of your bundled wireless router.

 
 
Step 11:
You can now replace the StarHub bundled router with a Linksys WRT1900AC.  Connect the ONT to the Internet port of the Linksys WRT1900AC.
 

Was this support article useful?

Additional Support Questions?

Search Again

CONTACT SUPPORT