Resetting WET54G to Factory Defaults

This article will show you how to reset your Wireless-G Ethernet Bridge back to its factory default settings.  There are two methods in resetting the wireless bridge:

Hard reset
Software reset

Hard reset

Press and hold the Reset button, which is located at the back panel of your Wireless Ethernet Bridge, for 30 seconds.

 

NOTE:  Observe the power light on the Wireless Ethernet Bridge while pressing the Reset button.  It should blink or flash as an indication that the device is properly resetting.

Software reset

Step 1:
Access the Wireless-G Ethernet Bridge’s web-based setup page.  For instructions, click here.

Step 2:
Click on the Password tab.

 

Step 3:
For the Restore Factory Defaults, click on Yes and then click on the Apply button to save the changes.
 

NOTE:  If a warning box appear, click OK to apply the changes.

 

這篇支援文章有幫助嗎?

尚有其他支援問題?
重新搜尋