text.skipToContent text.skipToNavigation

Configuring Captive Portal with Radius Authentication in LAPAC1200 or LAPAC1750

This article will show you how to configure Captive Portal with Radius Authentication in LAPAC1200 or LAPAC1750.  Follow the instructions below to learn more.
 
Step 1:
Make sure that the firmware version of your LAPAC1200 or LAPAC1750 is 1.0.07 or above.  If not, download the latest file from www.linksys.com/support.
 
Step 2:
Open the web-based setup page of your LAPAC and select the Captive Portal option then click Global Configuration from the drop-down navigation pane.
 
User-added image
 
Step 3:
Check Enable for Captive Portal and click Save.

 
User-added image

Step 4:
Click Portal profiles under Captive Portal
 
NOTE:  A profile is a defined set of login authentication, landing page, redirect after authentication, etc. for your guest network.  System supports up to two (2) profiles.
 
User-added image
 
Step 5:           
Select a Profile Name from Captive Portal Profile.  There are two (2) pre-defined Profile Names in the drop-down list.  Select one (1) and go to the next step.
 
NOTE:  In this example, Profile 1 is used.
 
User-added image
 
Step 6:           
Select Radius for your profile’s Authentication.
 
User-added image
 
Step 7:           
Fill out the necessary information on the page.
 
User-added image
  • Primary Server – Enter the IP address of the Radius Server on your network.
  • Primary Server Port – Enter the port number used for connections to the Radius Server.
  • Primary Shared Secret – Enter the key value to match the Radius Server.
  • Backup Server – The Backup Authentication Server will be used when the Primary Authentication Server is not available.
  • Backup Server Port – Enter the port number used for connections to the Backup Radius Server.
  • Backup Shared Secret – Enter the key value to match the Backup Radius Server.
Step 8:           
Click User-added image to apply changes.
 
Step 9:           
Manage the username and password accordingly in your Radius Server.  Refer to your Radius Server’s user manual for instructions.
 
NOTE:  You can also use different application tools that are available for free to help test and monitor your Radius Server.  These are very useful especially when you need to troubleshoot.  One example of this is NTRadPing To learn how to use this application, click here This kind of tool will help to rule out where it went wrong when user cannot grant Internet access via Captive Portal SSID with Radius Server authentication.  NTRadPing is not a Radius Server, it is a testing tool to verify against your Radius Server configuration.


Related Articles:
 
Configuring Captive Portal in LAPAC1200 or LAPAC1750
Configuring the Local User and Local Group on your LAPAC1200 or LAPAC1750

Was this support article useful?

Additional Support Questions?

Search Again

CONTACT SUPPORT