Resolving the “Your router was not successfully setup” error message during the initial installation of a Linksys Smart Wi-Fi Router

If you encounter a Your router was not successfully setup error message during the initial installation of your Linksys Smart Wi-Fi Router with a cable modem, follow the steps below to resolve the issue.
 
User-added image

Step 1:
Disconnect your Linksys Smart Wi-Fi Router from the cable modem.

Step 2:
Press the User-added image button at the back of the router with a pin or a paperclip for 30 seconds.

Step 3:
Reconnect the computer to the router wired or wirelessly.

Step 4:
Access the Smart Setup Wizard by opening a web browser and typing “http://192.168.1.1” or “http://myrouter.local”.

Step 5:
Start running the router's Smart Setup Wizard while disconnected from the modem until it displays the Your Internet cable is not connected correctly window.
 
User-added image

Step 6:
Using an ethernet cable, connect the modem to the yellow internet port of the router and click the User-added image button.

Step 7:
Finish running the Smart Setup Wizard until you can access the router's Linksys Smart Wi-Fi Tools page.

 
You should now have successfully resolved this error message.
 
 
Bypassing the Smart Setup Wizard after performing a reset on the Linksys Smart Wi-Fi Router

這篇支援文章有幫助嗎?

尚有其他支援問題?
重新搜尋