This article will discuss how to enable Hypertext Transfer Protocol Secure (HTTPS) for different Linksys devices. For a better understanding on HTTPS, click here.
Before you begin, ensure the following:
NOTE: The steps and images may vary depending on the model and firmware version of your Linksys device.
Click on the user interface of your Linksys device for step-by-step instructions:
Classic router user interface
Linksys Smart Wi-Fi user interface
Linksys Business Gigabit VPN Router user interface
Classic router user interface
Step 2:
Under Local Management Access > Access via, check the box beside HTTPS.
Step 3:
Once you're done, click
.
Linksys Smart Wi-Fi user interface
Step 2:
Click the Administration tab.
Step 3:
Under Local Management Access, check the box beside HTTPS.
Step 4:
Once you're done, click
.
Linksys Business Gigabit VPN Router user interface
Step 3:
Tick the radio button next to Enable for HTTPS.
NOTE: You will be prompted to change your router's password if it's currently set to default. Click OK to proceed with the password change then go back to Step 2.
Step 4:
Once you're done, click
.
Before you begin, ensure the following:
- Your Linksys device is properly set up
- You are logged in to the user interface of your Linksys device
NOTE: The steps and images may vary depending on the model and firmware version of your Linksys device.
Click on the user interface of your Linksys device for step-by-step instructions:
Classic router user interface
Linksys Smart Wi-Fi user interface
Linksys Business Gigabit VPN Router user interface
Classic router user interface
Step 1:
Click the Administration tab and go to the Management sub-tab.
Click the Administration tab and go to the Management sub-tab.

Step 2:
Under Local Management Access > Access via, check the box beside HTTPS.

Step 3:
Once you're done, click

Linksys Smart Wi-Fi user interface
Step 1:
Under Router Settings, go to Connectivity.
Under Router Settings, go to Connectivity.

Step 2:
Click the Administration tab.
Step 3:
Under Local Management Access, check the box beside HTTPS.

Step 4:
Once you're done, click

Linksys Business Gigabit VPN Router user interface

Step 3:
Tick the radio button next to Enable for HTTPS.

NOTE: You will be prompted to change your router's password if it's currently set to default. Click OK to proceed with the password change then go back to Step 2.

Step 4:
Once you're done, click
