text.skipToContent text.skipToNavigation

What to do before setting up your range extender

The Linksys range extender will only work if its wireless settings match the router’s/access point’s wireless settings.  The following should be done before setting up your range extender:
 
Identify the router/access point’s wireless settings

There are four (4) wireless settings that you need to identify on your router or access point before setting up your Linksys range extender.
  • Wireless network name (SSID)
  • Wireless channel
  • Wireless security mode (WPA/WPA2 Personal or WEP)
  • Wireless network password 
NOTE:  To learn how to check the wireless settings of your Linksys router, click here.  If you are using a non-Linksys router, refer to your router documentation or contact your router manufacturer for support. 
 
Reset the range extender
 
This process is optional.  You do not have to reset your Linksys range extender if it is a new device or you just recently purchased it.  To reset the range extender, press and hold the Reset button located at the top panel of the range extender for five (5) seconds to restore its factory default settings.
 
Connect the computer to the range extender
 
Connecting the range extender to the computer enables you to access the web-based setup page for manual configuration.  However, it is recommended to use a wired connection to ensure stable performance.  To do this, connect the range extender to the computer using an Ethernet cable.

Once you have performed the things mentioned above, you should be able to access the range extender’s web-based setup page and configure its settings.  Click here to learn more on how you can maximize the use of this product.


Related Articles:

Manually configuring a wireless range extender
Getting poor or no Signal on a wireless router due to physical obstructions and interference
Setting up the Linksys AC1200 Max Wi-Fi Range Extender, RE6500
Linksys wireless range extenders are not broadcasting a wireless network name or SSID
Resolving wireless detection setup error when setting up the RE1000 or RE3000W using a Windows-based computer

Was this support article useful?

Additional Support Questions?

Search Again

CONTACT SUPPORT