Setting up a Linksys router with Cable Internet Service on a classic web-based setup page
QUICK TIP: If you are unsure about the type of Internet connection you have, contact your Internet Service Provider (ISP).
To set up a Linksys router, you need to perform four (4) procedures using the computer that is registered to your ISP:
ii. Connecting devices together
iii. Checking the router’s LEDs
iv. Configuring a Linksys router for Cable Internet connection
QUICK TIP: To reconfigure a previously used router, reset the router to factory defaults. To do this, press and hold the Reset button of your router for 10 seconds. The Reset button is usually located at the back of the router.
Verifying that Internet connection is active
Connect the computer to the Cable modem using an Ethernet cable. If your computer is getting Internet connection, you may proceed to the next step. Otherwise, contact your ISP.
Connecting devices together
In this example, the Linksys E4200 is used.
Connect a computer to any of the router's numbered ports (1, 2, 3 or 4). If you are using a wireless computer, you will need to connect it first with an Ethernet cable.
Connect the power adapter of your router to the power outlet.
Checking the router’s LEDs
After connecting the devices together, check the lights on the front panel of the router. Ensure that the lights corresponding to the ports where the Ethernet cables are connected to are lit. For more information, click here.
Configuring a Linksys router for Cable Internet connection
Access the router’s web-based setup page. Open any web browser such as Internet Explorer®, Mozilla Firefox® or Safari®. Enter “192.168.1.1” in the address bar then press [Enter].
You will then be asked for your login details. Leave the User name field blank and enter “admin” in the Password field then click OK.
Thus, for Linksys router to work with your ISP, you have to enable the MAC Address Clone feature. This will allow your ISP to recognize the router as the computer with the registered MAC Address.
Select Enabled then click on Clone My PC’s MAC.
Checking Internet connection status
Once the MAC Address Clone feature is enabled, Internet status should be active. To check the Internet Connection status, follow the steps below.
NOTE: Ensure that the Internet Connection Type is set to Automatic Configuration – DHCP.
Click on the Status tab.
Check the Internet IP Address. If it has numbers, this means the router has been properly configured. If the Internet IP Address values are showing up 0.0.0.0, click on Release IP Address then the Renew IP Address buttons.
You should now be able to access the Internet. If not, powercycle the modem, the router, then the computer.
IMPORTANT: Powercycling the cable modem should be done with caution. Most Cable modems are bundled with Cable TV and phone connection. Some Cable modems also have backup batteries that may prevent it from being powered OFF even if the power adapter is detached from it. Refer to your ISP for detailed instructions on powercycling the modem.
To perform the powercycle process:
Power OFF the modem.
While the modem is OFF, unplug the power adapter from the router and shutdown your computer.
Power ON the modem and wait for its lights to go steady.
Power ON the router, then wait for its lights to go steady, then turn ON the computer.
Your Internet connection should now be active. If you’re still unable to go online, contact your ISP to reconfigure the modem.
Utilizing your network
After you successfully set up your Linksys router, you can now connect your wireless devices to your network. For video instructions, click on the links below:
Connecting Windows Computers to the Wireless Network (VIDEO)
Connecting your iPod®, iPhone® or iPad® to the Internet (VIDEO)
How to access the router’s web-based setup page