text.skipToContent text.skipToNavigation

Running Diagnostics on the LNE100TX

A Loopback ping is a self diagnostics test to determine if the TCP/IP is properly installed and configured correctly on the adapter. To perform a Loopback ping, refer to the instructions below.  

Performing a Loopback Ping

NOTE: To perform a loopback ping using Windows 98/ME, click here

Windows 2000/XP

Step 1:
Click Start, then Run

Step 2:
When the Run window opens, type “cmd” in the Open field, then click OK.

Step 3:    
When the MS DOS Prompt appears, type “ping 127.0.0.1” then press [Enter].

Step 4:
See if you’re getting four replies, Packets: Sent = 4, Received = 4, Lost = 0 (0% loss).

Windows 98/ME

Step 1:
Click Start, then Run. A window similar to Step 2 will appear.

Step 2:
When the Run window appears, type “command” in the Open field, then click OK.

Step 3:    
When the MS DOS Prompt appears, type “ping 127.0.0.1” then press [Enter].

Step 4:
See if you’re getting four replies, Packets: Sent = 4, Received = 4, Lost = 0 (0% loss).




Was this support article useful?

Additional Support Questions?

Search Again

CONTACT SUPPORT