- Accessing the web-based setup page of the Linksys WUMC710 media connector
Accessing the web-based setup page of the Linksys WUMC710 Wireless-AC Wi-Fi 5GHz Universal Media Connector Bridge with 4-Port Switch allows you to view its settings and current configuration. There are two (2) ways to do this:
You can use the WUMC710 media connector’s default static IP address if it is connected directly to a computer. To do this, follow the steps below:
Power ON the WUMC710 media connector and connect it to your computer using an Ethernet cable.
Assign a static IP address on your computer to 10.100.1.3. For instructions on how to assign a static IP address on a wired computer, click here.
Open a web browser and enter "10.100.1.1" in the Address bar. This is the default IP address of the WUMC710.
When the authentication window appears, leave the User Name field blank and enter the media connector's default password which is "admin". Click OK.
NOTE: If the password request screen does not appear, wait for two (2) minutes and try again.
To access the WUMC710 web-based setup page using its assigned IP address, you will need to determine it from the DHCP client table of the router. The WUMC710 media connector should already be set up and connected to the router. To access the media connector’s web-based setup page, follow these steps:
Connect the computer to the router either wired or wirelessly.
Access the web-based setup page of your router. Open a web browser and enter "192.168.1.1" in the Address bar. Log in by entering the router's administrator user name and password.
NOTE: The default administrator password of your router is admin and the User Name field is left blank. To learn how to access your router’s web-based setup page, click here. For instructions to access the Linksys Smart Wi-Fi web-based interface, click here.
Click Status then click the DHCP Client Table button.
NOTE: For instructions on how to access the DHCP client table through the Linksys Smart Wi-Fi web-based interface, click here.
Look for the WUMC710 device on the DHCP client table and take note of its assigned IP address.
Open a new tab on your browser or launch a new window and enter the IP address assigned to the WUMC710. When the authentication window appears, leave the User Name field blank and enter "admin" in the Password field. Click OK.
Encountering problems in accessing the web-based setup page
There are several reasons why you are unable to access the web-based setup page of the Linksys WUMC710 Wireless-AC Wi-Fi 5GHz Universal Media Connector Bridge with 4-Port Switch. The following may be some of the reasons:
• The computer you are using to access the web-based setup page is not associated to the WUMC710.
• The device is not powered ON.
• The password you entered is incorrect.
NOTE: If you are unable to access the web-based setup page of the WUMC710, you can reset the media connector. Using a straightened paper clip, press the Reset button on the bottom part of the device for approximately five (5) seconds. This will reset the media connector back to the factory default settings. For detailed instructions on resetting the wireless bridge or media connector, click here.
Was this support article useful?
Thank you for your feedback.
Please tell us how we can make this article useful.
Additional Support Questions?
LINKSYS LIVE CHAT
Help With Linksys.com
I have a question about a Linksys product or a Linksys Store promotion.
Get help with an issue or learn how to maximise the potential of my Linksys product.