- Setting up your Linksys router with a static IP account through Linksys cloud account
An Internet Protocol (IP) Address is a unique identifier which consists of four (4) sets of numbers from 0 to 255, separated by three (3) dots. This is required by all devices in the network to connect to the Internet.
A static IP Address is a fixed IP Address that is configured on the settings of a computer or router. There are Internet Service Providers (ISPs) that require you to enter certain numbers on your computer's TCP/IP settings to get online with their modem. These are the same numbers that you need to enter on your router’s web-based setup page to configure a static IP account.
IMPORTANT: Before setting up your router with a static IP, you need to obtain the following information from your ISP:
- Internet IP Address
- Subnet Mask
- Default Gateway
- Domain Name Server (DNS)
These settings must allow your computer to go online when connected to the modem, otherwise contact your ISP. You can also verify with them the type of Internet connection you are using.
To configure your router with static IP Address, follow the steps below.
NOTE: This feature is only available if you are locally connected to your network.
Connect the Modem to the Internet port of the Linksys Smart Wi-Fi Router.
Connect an Ethernet cable from your computer to any of the numbered ports at the back of the router.
NOTE: Your setup must look like this.
Plug the supplied power adapter to an electrical outlet and into the Linksys Smart Wi-Fi Router.
QUICK TIP: Make sure that the power light is solid before proceeding to the next step.
Launch your web browser and enter “192.168.1.1” in the Address bar. Then, press [Enter].
NOTE: In this example, we used Internet Explorer as the web browser.
You will be prompted to access the router. Enter “admin” in the Router Password field and click Log In.
NOTE: If you have changed your router password, enter the new password instead. In case you have forgotten your router password, click here to learn how to retrieve it.
You will receive a message that says The router is not set up. Check the box beside I understand that my network is currently open and not secure. I would like to use Linksys Smart Wi-Fi to configure my router’s security settings. Then click Continue.
Click the Internet Settings tab and then click Edit next to the Type of Internet Connection.
Select Static IP from the Connection Type dropdown menu.
Enter the necessary information provided by your ISP.
Click the button located at the lower right corner of the page.
On the Applying Changes pop-up box, click Ok.
Power OFF your Linksys Smart Wi-Fi Router for 30 seconds.
NOTE: Your Internet connection should be active once your router is turned ON. You will be prompted by a message that the Internet connection has been restored and you can use your Linksys cloud account.
Click Yes and proceed with associating your router to your Linksys cloud account. For instructions on how to log in to your Linksys cloud account, click here.
Expanding your network
You can also extend the range of your network through the use of other networking devices from Linksys like Powerline adapters. Click on the link below to know more about Powerline networking.
Was this support article useful?
Thank you for your feedback.
Please tell us how we can make this article useful.
Additional Support Questions?
LINKSYS LIVE CHAT
Help With Linksys.com
I have a question about a Linksys product or a Linksys Store promotion.
Get help with an issue or learn how to maximise the potential of my Linksys product.