How to enable the WPS feature

Wi-Fi Protected Setup™ (WPS) is disabled by default with the latest firmware on some Linksys Mesh Routers.  

This article will teach you how to enable this feature to connect your WPS-supported devices to your WiFi.  The images may vary depending on your device.  In this article, an iOS device is used.

 


Directions

Step 1:  
Log in to the Linksys app.  For instructions, click
here.

Step 2:  
Tap the menu icon in the upper-left corner.

Step 3:  
Tap Wi-Fi Settings.


sf334885-001_en_v1.png

Step 4:
Scroll down and tap on Connect a Device With WPS.


sf334885-002_en_v1.png

Step 5:
Toggle the WPS switch to the right to turn it ON.


sf334885-003_en_v1.png
 
Step 6:
To add a device, tap on Connect.  You have 2 minutes to push the WPS button on your device to connect it to your WiFi.  

NOTE:  To connect using a PIN or if your device asks for a router WPS PIN, tap Use a PIN.  

Was this support article useful?

Additional Support Questions?
Search Again