Cable Internet service is a form of broadband Internet access that runs through a TV’s local cable connection. This is accessed through a coaxial cable outlet that connects to the modem to broadcast the Internet information to the user.
IMPORTANT: Before setting up your router with Cable Internet connection, make sure that your computer is online using an Ethernet cable to the modem. If not, contact your ISP.
To configure your router with Cable Internet connection, follow the steps below.
NOTE: This feature is only available if you are locally connected to your network.
Connect an Ethernet cable from your computer to any of the numbered ports at the back of the Linksys router.
Plug the supplied power adapter to an electrical outlet and into the Linksys router.
QUICK TIP: Make sure that the power light is solid before proceeding to the next step.
Access your Linksys Smart Wi-Fi Account. For instructions, click here.
Click the Internet Settings tab.
NOTE: By default, the Type of Internet Connection is set to Automatic Configuration – DHCP.
Check the Enabled box next to MAC Address Clone and click Clone my PC’s MAC.
Click the button located at the lower right corner of the page.
On the Applying Changes popup box, click Ok.
Connect the Modem to the Internet port of the Linksys router.
Your Internet connection should now be active. You can now proceed with setting up and securing your wireless network. For instructions, click here.
Expanding your network
You can also extend the range of your network, especially in situations that require you to do so. This is through the use of other networking devices from Linksys like Powerline adapters. For more information about Powerline networking, click here.
Different ways in setting up your Linksys wireless router
Setting up the Linksys Smart Wi-Fi Router using Smart Setup
Troubleshooting tips to successfully connect to the wireless network