NOTE: In the steps below, a Linksys RE7350 on factory defaults was used.
Plug the range extender into a wall outlet and wait for the light to start blinking orange.
Connect a computer or a mobile device to the range extender's default WiFi name, which is Linksys Extender Setup – xxx.
NOTE: The xxx represents the last three characters of your range extender's MAC address which is located on the label at the back of the device.
Open a web browser and enter "192.168.1.1", "http://extender.linksys.com" or "http://RE7350-xxx" (the xxx represents the last three characters of the range extender’s MAC address). Then click or tap the Manual Setup link on the range extender's setup page.
Enter the default password which is admin then click or tap Login.
On the Wireless > Basic Settings page, click or tap Change to select the mode you need for your network in the Operation Mode section. For more information on the type of modes, click here.
Configure your manual settings such as the WiFi name and password for both 2.4 GHz and 5 GHz bands.
Click or tap Save when you’re done to apply the changes.