Setting up the Linksys WAPT1200AC to Range Extender mode

The Linksys WAPT1200AC AC1200 Wi-Fi Access Point can be set up in two (2) ways namely Access Point mode or Range Extender mode.  This article will show you how to set up the Linksys WAPT1200AC in Range Extender mode. 
 
Before you start the setup process, make sure to take note of the following:
  • An active 2.4 GHz or 5 GHz wireless network connection
  • Wireless network settings of your existing wireless network
- wireless network name (SSID)
- password or security key

QUICK TIP:  If you lost or have forgotten your wireless settings, click here to learn how to retrieve it.
 
Step 1:
Plug the Linksys WAPT1200AC into a wall outlet.
 
NOTE:  Wait for the Light Emitting Diode (LED) to change to amber.  To learn more about this device’s LED behavior, click here.
 
Step 2:
Using a computer or a mobile device, connect your device to the Linksys WAPT1200AC’s default SSID, which is Linksys AP Setup – xxx.  You should be connected to this wireless network to start the setup process.
 
QUICK TIP:  xxx are the last three (3) characters of the access point’s MAC address.  The MAC address of your access point is located on the label at the back of the device. 
 
Step 3:
Open a web browser and enter “http://ap.linksys.com” or “192.168.1.1” in the Address bar to launch the setup.
 
Step 4:
Click Start Setup.
 
User-added image
 
Step 5:
Create your admin password and your password hint then click Save once done.
 
User-added image
 
Step 6:
Select the As a wireless range extender option then click Next.
 
NOTE:  No Ethernet cable is needed for the Range Extender mode.
 
User-added image
 
Step 7:
Select your existing wireless networks and enter your password when prompted.
 
NOTE:  If you have a dual-band network, you should see the SSID of both bands.
 
User-added image
 
QUICK TIP:  If you have a hidden SSID, click Manually Enter Network Name and Password.  Otherwise, wait until it detects your wireless networks and select your network.
 
User-added image          
 
Step 8:
Configure your extended networks.  This is the wireless network name your wireless clients will connect to. 

NOTE:  You can use the same wireless name as your current SSID or enter a different wireless network name.
 
User-added image
 
Step 9:
The Spot Finder page only appears on Range Extender mode.  This feature determines the signal strength between your device and the router.  If it is too far, unplug and move it closer to your router.  Then, reconnect to the Linksys WAPT1200AC’s default SSID and go to http://ap.linksys.com to continue the setup.
 
User-added image
 
You should now have set up your Linksys WAPT1200AC to Range Extender mode. 
 
QUICK TIP:  You can click Print this to secure a copy of your settings.
 
User-added image
 
When Linksys WAPT1200AC is in Range Extender mode, the top header will read Dual Band Wireless Range Extender.  You can log in to the web-based setup page to view the updated top header name.  To learn how, click here.
 
User-added image
 
Alternatively, you can also configure the Linksys WAPT1200AC to work on Access Point mode.  To learn how, click here.

Was this support article useful?

Additional Support Questions?
Search Again