Adding a node to the Velop system using an Android mobile device

If you have an existing Velop system and you would like to add a child node using an Android™ mobile device, follow the instructions below.

Directions

Step 1:
Launch the Linksys app and log in to your Linksys server account.

Step 2:
Tap on the menu User-added image icon and then tap Set Up a New Product.

User-added image

NOTE: Images may vary.

Step 3:
Tap on Add Another Node to xxxx (where xxxx is your existing WiFi name).

User-added image

Step 4:
Tap on To extend my Wi-Fi with a new child node.

User-added image

Step 5:
Turn on Bluetooth® if prompted. Otherwise, tap I would rather set up without Bluetooth.

User-added image

Step 6:
The Linksys app explains how to place additional nodes. Tap Next to continue.

User-added image

Step 7:
Plug the additional node into a power source within range of another node then tap Next.

User-added image

Step 8:
Node detection will begin. This could take up to 3 minutes.

User-added image

Step 9:
Tap on Yes, it’s Blinking Purple as soon as the light blinks purple.

User-added image

Step 10:
The app will apply the settings from other nodes. This could take up to 6 minutes.

User-added image

NOTE: You will be notified when your node was positioned properly. Otherwise, the on-screen instructions will show recommendations on how to correctly position your node. Tap Next to continue.

User-added image

Step 11:
Select a node name then tap Next.

NOTE: It is recommended that the name corresponds to the actual location of your node at home. This will allow you to identify multiple nodes through the Linksys app. To customize the name, tap Name it something else.

User-added image

Step 12:
You have successfully added a child node. Tap Next.

User-added image

Step 13:
If you want to add another child node, tap Add a Node. Otherwise, tap That’s it for Now. You can also add another node later by logging into the Velop dashboard and following the same steps above.

User-added image

Step 14:
The node will perform a firmware check to verify if your node is up-to-date. If a new firmware is available, the Linksys app will update automatically. Otherwise, you will land on the Your Wi-Fi is ready screen and you can tap on Go to Dashboard.


User-added image

You have now successfully added a node to your existing Velop network.


Related Articles:

How to add a wired child node to the Velop system using the web interface
How to add a wired child node to the Velop system using the Linksys app

這篇教學文章是否有用?

您有其他支援方面的問題嗎?
再次搜尋