text.skipToContent text.skipToNavigation

Accessing the Wireless Video Camera's web-based setup page using a Mac® computer

The Linksys Wireless Video Cameras have a built-in web-based setup page that allows you to customize settings and set up advanced properties.

NOTEBefore accessing the camera’s web-based setup page, make sure that the Wireless Video Camera is powered ON and that it’s wired to one of the Ethernet ports on the router (ports 1, 2, 3 or 4).

Accessing the Wireless Video Camera’s Web-Based Setup Page

Step 1:
Open a web browser such as Safari®.

Step 2:
Enter "" on the Address bar then press [Return].

NOTE:  If the IP address of the video camera has been changed, type the video camera’s IP address in the Address bar instead.

User-added image

NOTE:  If you forgot the video camera’s IP address, you can press the Reset button underneath the antenna for 30 seconds.  This procedure will reset the camera to factory defaults.  The Wireless Video Camera’s IP address will revert back to and the user name and password will go back to the default “admin” after resetting.  For WVC54GCA and WVC80N cameras, you can either run the Setup Wizard or launch the Linksys Camera Utility to find out the IP address of your camera.

Step 3:
A new window will prompt for a Name and Password. Enter “admin” on the Name and Password fields then click Log In.

NOTE:  If the password of the camera has been changed, type the Wireless Video Camera’s new password in the Password field instead.

Related Articles:
Configuring the IP address of the camera
Setting up a password on a Linksys Wireless Video Camera
Resetting Your Linksys Video Camera to Factory Default

Was this support article useful?

Additional Support Questions?

Search Again