- Resetting WET54G to Factory Defaults
This article will show you how to reset your Wireless-G Ethernet Bridge back to its factory default settings. There are two methods in resetting the wireless bridge:
Press and hold the Reset button, which is located at the back panel of your Wireless Ethernet Bridge, for 30 seconds.
NOTE: Observe the power light on the Wireless Ethernet Bridge while pressing the Reset button. It should blink or flash as an indication that the device is properly resetting.
Access the Wireless-G Ethernet Bridge’s web-based setup page. For instructions, click here.
Click on the Password tab.
For the Restore Factory Defaults, click on Yes and then click on the Apply button to save the changes.
NOTE: If a warning box appear, click OK to apply the changes.
Was this support article useful?
Thank you for your feedback.
Please tell us how we can make this article useful.
Additional Support Questions?
LINKSYS LIVE CHAT
Help With Linksys.com
I have a question about a Linksys product or a Linksys Store promotion.
Get help with an issue or learn how to maximise the potential of my Linksys product.