text.skipToContent text.skipToNavigation

Setting-Up a PlayStation®2 with a Wireless-G Ethernet Bridge

This article will give you instructions on how to set up PlayStation 2 to get online using the Linksys Wireless-G Ethernet Bridge.

NOTE:  Before trying to connect your Wireless-G Ethernet Bridge to a wireless network, take note of your SSID, Wireless Security and/or Network Key. To get these settings if you’re using a Linksys, click here. If you’re using a non-Linksys router and you do not have these settings, consult your wireless router’s user guide or contact the manufacturer for assistance.

Make sure that the PlayStation®2 works when wired to the router before proceeding. If it’s not working and you have a Linksys router, click here to set it up. If you’re not using a Linksys router consult the user guide or contact the manufacturer for assistance.

Setting-Up the Wireless-G Ethernet Bridge 

Step 1:
Connect the Wireless Ethernet Bridge to your router using an Ethernet cable.  

Step 2:
Access the Wireless-G Ethernet Bridge’s web-based setup page. For instructions, click here

Step 3:
On the Ethernet Bridge’s setup page, look for the SSID field and enter the wireless network’s SSID

Step 4:
Under Network Type, select Infrastructure

Step 5:
If WEP is not enabled on the wireless router, look under Security and select Disable then proceed to Step 10

If WEP is enabled, under Security select Enable. Click Edit Security Settings then proceed to the steps below. 

Step 6:
On the WEP Encryption window, select the same Default Transmit Key as your router’s. In this example, we selected 1

Step 7:
Select the same WEP Encryption level either 64-Bit(10 hex digits) or 128-Bit(26 hex digits). In this example we selected 64-Bit(10 hex digits).  

Step 8:
Enter the wireless network’s WEP Key based on the Default Transmit Key selected. Since we selected Key 1, we’ll enter the WEP Key in the Key 1 field.  

Step 9:

Click .  

Step 10:
On the web-based setup page appears, click Site Survey. When the Site Survey window appears, click Refresh and select your wireless network’s SSID by clicking on it.   

Step 11:
Connect one end of an Ethernet cable to the Wireless-G Ethernet Bridge’s Ethernet port and the other end to the PlayStation®2’s.
 

Was this support article useful?

Additional Support Questions?

Search Again

CONTACT SUPPORT