- Configuring the Access Control List on a LGS528P Switch
This article will provide you the instructions on how to configure the Access Control List on a LGS528P Switch Using the MAC Address:
Access the managed switch’s web-based setup page. To know how, click here.
On the setup page, click the Configuration tab and then click Access Control List.
Select MAC Based ACL, then click Add.
Create an ACL Name to identify which particular rule should effect.
Select MAC Based ACE.
Select the ACL that you created under ACL Name and then click on Search.
Click Add to create a Rule.
I. Permit – The 1st Rule is to Permit a connection if it’s the correct MAC. This rule is to allow the associated MAC address of the device to have Internet or Network Access.
Select ACL Binding.
Select the corresponding Port checkbox where you created an ACL and then click Edit.
Check MAC Based ACL and then click Apply.
To re-activate the Port, follow the steps below:
Go to Configuration > Port Management > Port. Click on the Port and then Edit.
Check Reactivate then click Apply.
To know about the Linksys Managed Switches, click here.
Was this support article useful?
Thank you for your feedback.
Please tell us how we can make this article useful.
Additional Support Questions?
LINKSYS LIVE CHAT
Help With Linksys.com
I have a question about a Linksys product or a Linksys Store promotion.
Get help with an issue or learn how to maximise the potential of my Linksys product.