text.skipToContent text.skipToNavigation

Setting up a Linksys router for DSL Internet using PPPoE settings

Some DSL Internet Service Providers (ISPs) use Point to Point Protocol over Ethernet (PPPoE) Authentication to establish Internet connection with their end-users.  This article will guide you in setting up the router’s PPPoE feature.

NOTE:  This article assumes that you already have the username and the password for your DSL Internet connection.  For more information, click here.

Step 1:
Access the router’s web-based setup page.  For instructions, click here.  
If you’re using a Mac® computer, click here instead.

Step 2:
On the Setup tab, click the drop-down arrow for Internet Connection Type then select PPPoE.

 

User-added image


Step 3:
Enter the Username and the Password for your DSL Internet connection.

 

User-added image


Step 4:
Select Keep Alive.

 

User-added image


Step 5:
Click Save Settings.

Step 6:
Click the Status tab.

 

User-added image


Step 7:
Verify that the Connection Type is PPPoE then click Connect.

User-added image

 

Related Articles:

Resolving PPPoE error messages when setting up router
Setting up WEP, WPA or WPA2 wireless security
Setting up a Linksys router with Cable Internet service
Setting up a Linksys router with DSL Internet service
Setting up the IPv6 and IPv4 SPI Firewall Protection of the Linksys Wi-Fi Router

Was this support article useful?

Additional Support Questions?

Search Again

CONTACT SUPPORT