How to add or remove motion-sensing devices on Linksys Aware

This article will guide you on how to add or remove Linksys Aware motion-sensing devices.

Below are some helpful tips for selecting devices:

 

  • Only choose devices for a location where you care about detecting motion. Having just a few motion-sensing devices is recommended.
  • To prevent overlap and interference, make sure each device is at least 15 ft away from other motion-sensing devices on your system.
  • Choose devices that are not hidden behind obstacles like a TV or inside a closet. Limit the number of walls between each device.
  • Choose devices that are centrally located in a room and not next to walls shared with neighbors.
  • Do not choose devices that are battery-operated.
  • You can add up to three devices per node.
  • To detect location-specific motion, you need at least three devices.

 


 

Adding compatible smart home devices to act as motion sensing devices

1. If you have not subscribed to Linksys Aware yet, make sure to subscribe first. For instructions, click here.

2. In the Linksys Aware screen, click on the menu User-added image icon.

User-added image

If you are on any of the following screens, tap either See Devices I Can Add or Check for Compatible Devices. Linksys Aware will automatically start scanning for devices on your network.

 User-added image User-added image
                                
3. Click on Add smart home device. 

User-added image

4. You can either wait until the scan is complete or start adding devices. Then, scroll to the bottom and click Add.

TIP: You can add up to three compatible devices per node.

User-added image

You have now added additional motion devices.

 



Removing a motion-sensing device

1. Click on the menu User-added image icon within Linksys Aware.

User-added image

2. From the Manage Devices list, tap on the ellipsis icon next to the device that you want to remove and then tap on Remove device.

User-added image

3. Tap on Remove device one more time to confirm.

User-added image

 

Was this support article useful?

Additional Support Questions?
Search Again