Overview of the Advanced feature on the Linksys FGW5500

This article will give you an overview of the Advanced feature of the Linksys FGW5500.

MAC Filtering
IP Filtering
Parental Control
Port Forwarding
Port Triggering
Static Routing
Rate Limit
UPnP
Dynamic DNS

MAC Filtering

sf47035-001_en_v4.png

Select Blacklist or Whitelist, click Add, enter the MAC address of a client, and click Apply.
 
sf47035-002_en_v4.png
 
  • MAC Filtering Mode - Users can block or allow clients with certain MAC addresses to access the router.
  • Disable - Any clients can establish the connection.
  • Blacklist - Only clients with MAC addresses in Access Control List will be blocked, other clients can establish the connection.
  • Whitelist - Only clients with MAC addresses in the Access Control List can establish the connection, other clients will be blocked.


IP Filtering

Select Blacklist or Whitelist, then click Add, enter the IP address of a client, and click Apply.

 
sf47035-003_en_v4.png
 
  • IP Filtering Mode - Users can block or allow clients with certain IP addresses to access the router.
  • Disable - Any clients can establish the connection.
  • Blacklist - Only clients with IP addresses in Access Control List will be blocked, other clients can establish the connection.
  • Whitelist - Only clients with IP addresses in the Access Control List can establish the connection, other clients will be blocked.


Parental Control

You can
configure the Parental Control features in this section.

sf47035-004_en_v4.png
 


Port Forwarding

Click Add to configure the Port Forwarding feature.

sf47035-005_en_v4.png
 
Fill out the required settings and click Apply.

sf47035-006_en_v4.png
 
  • Enabled - Check the box to enable or disable the Port Forwarding service.
  • Application Name - Create a name for the Port Forwarding service.
  • Protocol - Set the protocol to TCP, UDP, or Both.
  • WAN Port - Set up a range of WAN ports.
  • LAN Port - Set up a LAN port.
  • LAN IP - Set up LAN IP address.


Port Triggering

Click Add to configure the Port Triggering feature. Fill out the required settings and click Apply.

sf47035-007_en_v4.png
 


Static Routing

Click Add to configure the Static Routing feature.

sf47035-008_en_v4.png
 
You can enter the required settings and click Apply.

sf47035-009_en_v4.png
 


Rate Limit

Select a client from the Selection drop-down menu.

sf47035-010_en_v4.png
 
Enter a Downlink (Mbps) and Uplink (Mbps) limit, click Add, then click Apply.

sf47035-011_en_v4.png
 


UPnP

UPnP is disabled by default, check the box to enable this feature, and click Apply to save your setting.

sf47035-012_en_v4.png
 


Dynamic DNS

To enable DDNS, check the box.

sf47035-013_en_v4.png
 
Select a provider and enter your DDNS information and click Apply.

sf47035-014_en_v4.png

這篇支援文章有幫助嗎?

尚有其他支援問題?
重新搜尋