Mounting the Linksys FGMM601

The Linksys FGMM601 5G Outdoor Router can be wall and pole mounted.  Follow the instructions below to know how.

Before you begin, take note of the following:
 
  • It is recommended that you consult a qualified technician for this installation.
  • Gather the mounting kit that came with your Linksys FGMM601.
  • Do not connect or remove the SIM card when the router is powered ON.
  • The default WiFi name and password are located on the product label of the router.
  • It is recommended to install your router less than 30 m from a base station.

1. Assemble the device and rotate the holder with four sets of M6 screws (with spring washer and flat washer).

2. Tighten the M8 screw, flat washer, spring washer, and nut from the pole holder.  Then, assemble with the rotate holder.
 

3. Tighten two M8 nuts of the mounting kit.

4. Adjust the router antenna bearing and tilt it to the desired angle.  Fasten two M8 nuts.

 
 
Pole mounting

1. Loosen the M8 long bolt, flat washer, spring washer, and nut through the holes of the back plate and the pole holder.

2. Place the washers and tighten the nuts to secure the mounting kit.

 

You have now successfully mounted the Linksys FGMM601.

這篇支援文章有幫助嗎?

尚有其他支援問題?
重新搜尋