How to change the WiFi settings on a Linksys E9450-SG for Singtel

The following steps are for the Linksys E9450-SG for Singtel Dual-Band Easy Mesh WiFi 6 Router set up as a parent node. If you have any child nodes in your network, once you apply the changes to your parent node, the parent node will then sync the WiFi changes to the rest of your child nodes.

NOTE: If your router is set up as a Non-Mesh System, go to the Wireless tab and change the WiFi settings.

 
Step 1:
Log in to the router's web interface. For instructions, click
here.

Step 2:
Click the General tab.


Step 3:
On the left side of the screen, click Mesh Setup.


Step 4:
Change the WiFi settings then click Apply/Save.

Wait until the settings are saved. The WiFi will temporarily disconnect until your settings are saved.

Step 5:
Once your new settings have been saved, connect to your new WiFi name then click Done.

 
The WiFi settings of your router have been successfully changed.

Was this support article useful?

Additional Support Questions?
Search Again