How to set up the Linksys Dual-Band WiFi Router as a Wireless Bridge

A Wireless Bridge allows the router to act like a wireless adapter.  It connects wirelessly to another wireless router and allows the devices that are wired to it to go online.
 
By selecting Wireless Bridge mode, your router will function as a wireless ethernet bridge instead of a router.  A wireless ethernet bridge adds wireless networking capability to any wired (ethernet) device.  Make sure that you connect the wired device to one of the ethernet ports of this router.

 
User-added image

Before you begin:
  • You must have an existing Wi-Fi (apart from your Linksys Dual-Band WiFi Router)
  • Write down the network name and wireless password of your existing Wi-Fi
  • Disconnect anything connected to the internet port of the Linksys Dual-Band WiFi Router
  • Plug in the ethernet device to the Linksys Dual-Band WiFi Router into a LAN port that you want to give Wi-Fi capabilities
  • Plug in the computer to another LAN port, this will be the computer to use for configuring the Wireless Bridge settings
 
Follow the steps below to know how to setup the Linksys Dual-Band WiFi Router as a Wireless Bridge:
 
Step 1:
Log in to the Linksys Dual-Band WiFi Router's web interface.  For instructions, click here.
 
Step 2:
Click the Configuration tab.
 
Step 3:
Click Connectivity, and then select WAN Setup.

 
User-added image
 
Step 4:
Under Internet Setup, select Wireless Bridge.

Step 5:
In the Network Name (SSID) field, enter the existing Wi-Fi name and then select which wireless band you want your device on in the Network Band portion.  If your existing Wi-Fi has security, select the same Security Mode and enter the wireless password in the Passphrase portion. 


NOTE:  The Linksys Dual-Band WiFi Router supports WPA2™ Personal and WPA™ Personal security types.
 
User-added image

Step 6:
Click Save to keep the changes made. 
 
Step 7:
Your ethernet device will now have Wi-Fi capabilities using the Linksys Dual-Band WiFi Router.  You can now connect up to four ethernet devices into the LAN ports of the router to give them Wi-Fi capabilities such as a network drive, or a computer, even without a Wi-Fi adapter.
 
NOTE:  To log in to the Linksys Dual-Band WiFi Router web interface again, you can type "http://Linksysxxxx" which is the default device name located on the bottom of the Linksys Dual-Band WiFi Router in the Wireless Network portion.  To determine the new IP address of the router, you can check the client table of the main router.  
 
User-added image

Was this support article useful?

Additional Support Questions?
Search Again