Upgrading the firmware of your Linksys Wireless-AC and Wireless-N Access Point

The firmware of your Linksys Wireless-AC and Wireless-N Access Points can be upgraded using the HTTP / HTTPS, or TFTP methods.  Go to the Linksys Support Site for the latest firmware release of your access point, then download and save it to your computer to perform the upgrade.

IMPORTANT:  During the firmware upgrade, do NOT disconnect the access point from the computer or power OFF the device.  It will reboot automatically when the firmware upgrade is complete.

 
User-added image

Upgrading the firmware occurs in the device's web-based setup page.  To gain access to this page, click here for the step-by-step instructions.  Once the setup page is up, click on Maintenance > Firmware Upgrade then choose one among the three options to proceed with the upgrade.

I. 
From Local PC
II. From TFTP Server
III. From internet
 
From Local PC:
 
Step 1:
Click the Choose File button and navigate to the location of the firmware file that you downloaded earlier.
 
Step 2:
Select the firmware file.  Its name will appear in the Upgrade File field.
 
Step 3:
Click the Upgrade button.

Step 4:
Click OK to start the firmware upgrade.

 
From TFTP Server:
 
Step 1:
Enter the path of the firmware file on the Source File field.  Then enter the IPv4 address of the server in the TFTP Server field.
 
NOTE:  The firmware file supplied must be an .img file type.

Step 2:
Click the Upgrade button to start the upgrade process.
 
From internet:
 
​NOTE:  This option is only available in supported access points.

 
Step 1:
Click the Check for Upgrade button to verify if there is a new firmware available.
 
Step 2:
Click OK on the pop-up dialogue box to start the firmware download and upgrade if a new version is available.

 
You should now have upgraded the firmware of your Linksys Wireless-AC or Wireless-N Access Point.

Was this support article useful?

Additional Support Questions?
Search Again