Wall-mounting a powerline AV network adapter

This article will show you the process of wall-mounting the PLE300/PLS300.

The adapter has four (4) wall-mount slots on its back panel.  The distance between two adjacent slots is 60mm (2.36 inches).  Two (2) screws are needed to mount the adapter.

Step 1:
Drill two holes into the wall and make sure that the holes are 60mm (2.36 inches) apart from each other.

QUICK TIP:  Make sure that the location is within reach of an electrical outlet.

Step 2:
Insert a screw into each hole and leave 3mm (0.12 inches) of its head exposed.

Step 3:
Maneuver the adapter so the two wall-mount slots line up with the two screws.

Step 4:
Please place the wall-mount slots over the screws and slide the adapter down until the screws fit snugly into the wall-mount slots.

 

Was this support article useful?

Additional Support Questions?
Search Again