Connecting devices to the Linksys WAPT1900AC using WPS

The Linksys WAPT1200AC AC1200 Wi-Fi Access Point has Wi-Fi Protected Setup™ (WPS) button that can be used to connect devices to the network.  This article will show you the steps on how to do so.
 
NOTE:  Make sure that your access point is already set up, whether in Range Extender mode or Access Point mode.  For instructions on how to set up the Linksys WAPT1200AC in Range Extender mode, click here.  To set up the product on Access Point mode, click here.
 
Step 1:
Press the WPS button on the device that you want to connect to the access point.
 
Step 2:
Press and hold the WPS User-added image button at the side panel of your Linksys WAPT1200AC.  When the connection is complete, the Light Emitting Diode (LED) at the front will be solid green.  If the LED is blinking amber rapidly, the connection failed.  Retry Steps 1 and 2 to fix the concern.
 
You have now successfully connected your device to the Linksys WAPT1900AC using WPS.

Was this support article useful?

Additional Support Questions?
Search Again