Overview of the Status page of the Linksys RE7350 and RE7310

This article gives you an overview of the Status page for the Linksys RE7350 Max-Stream™ WiFi 6 Range Extender and Linksys RE7310 MAX-STREAM™ WiFi 6 Range Extender.

To use this feature, access the web interface of your range extender.  For instructions, click
here. 
           
The table below shows the settings that can be configured under Status:
 
FeatureDescription










 
 
Device Info

This is available in both Access Point and Range Extender modes.
 
 User-added image
  • Firmware Version - The most current firmware installed on your range extender.
  • Firmware Verification - The MD5 checksum of the firmware is displayed.
  • System Time - Current time of the range extender identified by the NTP protocol.
  • Up time since last restart - Time elapsed since the last restart.
  • Extender Mac Address - The MAC address of the range extender's ethernet port.
  • Network Address - This is the network IP address of the range extender.










 

Ethernet Statistics

If you have a client connected to the ethernet port of the range extender or you are using the Wired Range Extender mode, you can view the ethernet statistics in this page.

NOTE:  This is only available for the Linksys RE7350.

Access Point mode
 
User-added image

Range Extender mode

User-added image
 
  • Ethernet port status - Indicates whether a device is connected to the range extender's ethernet port.
  • Packets Sent (TX) - The number of packets transmitted from the range extender to the wired device.
  • Packets Received (RX) - The number of packets received by the range extender from the wired device.
  • Packets Dropped (TX) - The number of packets dropped on transmission from the range extender to the wired device.
  • Packets Dropped (RX) - The number of packets dropped on transmission from the wired device to the range extender.
  • Collisions - The number of collisions occurring on the ethernet port.
  • Errors - The number of errors logged on the ethernet port.
  • Ethernet Port Lights - Turn the ethernet port lights on or off.
  • Wired Clients Table - View the MAC addresses and IP addresses of devices connected to the range extender with an ethernet cable.
  • Clear - Click this to reset counters.







 

WLAN Statistics
This is available in both Access Point and Range Extender modes.  You can use this tool to check your WLAN statistics.

Access Point mode
 
User-added image

Range Extender mode

User-added image
User-added image 

NOTE:  You can click the Wireless Devices Table to view clients connected to the range extender or click refresh.  You can also rename the clients here.

Was this support article useful?

Additional Support Questions?
Search Again