Getting to know the Linksys AC1750 Pro Dual-Band Access Point, LAPAC1750PRO

The Linksys AC1750 Pro Dual-Band Access Point, LAPAC1750PRO provides continuous and high-speed access between wireless and Ethernet devices.  It is an advanced, standards-based solution for wireless networking in businesses of any size.  The access point (AP) enables wireless local area network (WLAN) deployment while providing state-of-the-art wireless networking features.
The LAPAC1750PRO works in Standalone Mode, which means it is an individual access point in your network.  You manage the device through a web-based setup page or Simple Network Management Protocol (SNMP).


Product Features

  • 802.11ac
  • Dual-Band PoE Access Point
  • 3x3 MIMO
  • Data rates:  LAPAC1750 up to 450 Mbps (2.4 GHz)/ up to 1300 Mbps (5 GHz)
  • Supports up to 8 SSID for each band (16 Total)
  • AP Isolation
  • Workgroup Bridge Mode
  • WDS support
  • Captive Portal support
  • Advanced Security and Preventions (802.1x Supplicant, SSID to VLAN Mapping, MAC Access Control, Rogue AP detection)
  • IPv6 Support
  • Rogue AP Detection
  • Cluster
  • 2 -10/100/1000 Mbps

Top panel

LED Color





System is booting


System is normal; no wireless device connected



Software upgrade in process


System is normal; at least 1 wireless device connected



Booting process or update failed; hard reset or service required

Bottom panel

  • Power Port Connect the AC power adapter to this port.  The power adapter uses 12V.

NOTE:  Use only the adapter that came with your access point.

  • Ethernet Port 1 (Power over Ethernet (POE))  — Use RJ45 (Cat5e or better) cable to connect LAP1750PRO to network devices like routers, switches or computers.  This port supports PoE+ (IEEE802.3at).  You may use the port to power LAPAC1750PRO by using PoE+ switch or injector.

    NOTE:  PoE has higher precedence over AC.  When both PoE and AC power adapter are connected to LAPAC1750PRO, the device will be powered by PoE.

  • Ethernet Port 2  — This is a non-PoE Ethernet port.  It can be used instead of Ethernet port 1 but requires AC power adapter to power LAPAC1750PRO access point.

NOTE:  Ethernet Port 1 and Port 2 can be used together in Link Aggregation mode when supported by the connected devices.  In this configuration, it is highly recommended that AC power and PoE be used in tandem to support power failure and/or link failure.

  • Reset button  Press and hold this button for less than 15 seconds to powercycle the device.  Press and hold for more than 15 seconds to reset the device to factory default settings.

  • Kensington Lock – Slot for security lock

Product Requirements
  • No OS limitations
  • Browser
  • Browser must support JavaScript
  • IE 7.0 or later
  • Chrome 8 or later
  • Firefox 3.5 or later
  • Safari 5 or later

Related Video:

Getting to know the Linksys LAPAC2600 (VIDEO)


Was this support article useful?

Additional Support Questions?
Search Again