Connecting the Linksys LAPPI30W High Power Gigabit PoE+ Injector to a device

The Linksys LAPPI30W High Power Gigabit PoE+ Injector offers a quick and easy setup with plug and play installation.  It has Power over Ethernet (PoE+) capability that can provide up to 30W power supply.  It also reduces the wiring cost of AC power by using a standard CAT5, CAT5e or a preferred better cable that can carry both power and data to PoE devices.

This article will guide you on how to set up the Linksys LAPPI30W High Power Gigabit PoE+ Injector.

 
Step 1:  
Connect an ethernet cable into the PoE port on the PoE injector and connect the other end to the PoE port of your PoE device such as a PoE access point.

Step 2:
Connect a second ethernet cable into the LAN port of the PoE injector and the other end to an ethernet port of your network like a switch or a router.

Step 3:
Connect the power cord to the PoE injector and to a power outlet.
 
User-added image

Was this support article useful?

Additional Support Questions?
Search Again