Setting up the Linksys RE9000 to Access Point mode

The Linksys RE9000 Range Extender can be set up in two ways, through Range Extender mode or Access Point mode.  This article will show you the steps on how you can set it up on Access Point mode.
 
Before you begin, make sure to have the following:
  • A wireless computer MUST be used
  • Have an ethernet cable ready
  • Make sure no other devices are hardwired to the Linksys RE9000

IMPORTANT:  Only one ethernet connection must be detected at the time of setup.  Once setup is complete, you can then hardwire additional devices
 
Step 1:
Turn ON the Linksys RE9000 and wait for the light indicator to blink orange.
 
Step 2:
Using a wireless device, locate and connect to the Linksys Extender Setup Wi-Fi.
 
Step 3:
Once connected, open a browser and go to
http://extender.linksys.com to launch setup.
 
NOTE:  If the Linksys RE9000 has not detected a DHCP server, it defaults to its IP address, 192.168.1.1.
 
sf49718-001_en_v2.png
 
QUICK TIP:  If you want to bypass the setup wizard, click on Manual Setup.
 
Step 4:
Select the As a wired ranged extender (Access point) option and click Next.

sf49718-002_en_v2.png
 
Step 5:
You will be prompted to connect an ethernet cable from your Linksys RE9000 to your existing router.  Connect the cable and click Got it.

 
sf49718-003_en_v2.png

Step 6:
Create a Network name and Password for your extended network then click Change.
 
NOTE:  If you want to create unique names for each radio band, uncheck the Band Steering.  Leaving Band Steering ON is the recommended setting.

sf49718-004_en_v2.png
 
Step 7:
Change the administrative password of your Linksys RE9000 then Save settings.

 
sf49718-005_en_v2.png

Step 8:
Register your Linksys RE9000 by entering your Email Address in the field.  Click Next once done.
 
QUICK TIP:  Click Skip if you want to bypass this step.
 
sf49718-006_en_v2.png

Step 9:
Connect your wireless device to the new Wi-Fi.  Once you are connected, the Next button will turn blue.  Click Next.

 
sf49718-007_en_v2.png

NOTE:  At this point, you can now use http://extender.linksys.com to access the range extender’s web-based setup page.
 
Your Linksys RE9000 should now be set up.  You can click Print this to secure a copy of your settings.
 
sf49718-008_en_v2.png

When on Access Point mode, the Linksys RE9000’s top header will read Next-Gen AC Wireless Access Point.
 
sf49718-009_en_v2.png

 

Related Article:

Setting up the Linksys RE9000 to Range Extender mode

Related Videos:

Setting up the Linksys RE9000 to Range Extender mode (VIDEO)
Setting up the Linksys RE9000 to Access Point mode (VIDEO)
 Getting to know the Linksys RE9000 Range Extender (VIDEO)
 

 

Was this support article useful?

Additional Support Questions?
Search Again