Manually setting up the Linksys RE9000

In situations where you want to bypass the Linksys RE9000 Range Extender’s setup wizard, you can follow the steps below to manually configure the range extender.

NOTE: This article assumes that your Linksys RE9000 is on factory defaults. To reset the Linksys RE9000, press the Reset button for 5 seconds.
 
Step 1:
Turn ON the Linksys RE9000 and wait for the light indicator to blink orange.
 
Step 2:
Using a wireless device, locate and connect to the Linksys Extender Setup Wi-Fi.
 
Step 3:
Once connected, open a browser and go to http://extender.linksys.com to launch setup.
 
NOTE: If the Linksys RE9000 has not detected a DHCP server, it defaults to its IP address,
192.168.1.1.
 
Step 4:
Click the Manual Setup link at the bottom.

User-added image
 
Step 5:
Enter “admin” in the Password field then click Login.

 
User-added image

Step 6:
You have now bypassed the Setup wizard. Configure your manual settings as needed. 
 
NOTE: In order to configure the upstream connection, you must use the Wizard option by going to Wireless > Wizard.

 
User-added image

Select your mode of choice, click Change and follow the on-screen instructions. 
 
NOTE: If you are changing to Access Point (Wired Range Extender) mode, make sure to have an ethernet cable ready to connect your Linksys RE9000 to your router.
 
User-added image

Related Articles:

Setting up the Linksys RE9000 to Access Point mode
Setting up the Linksys RE9000 to Range Extender mode

Related Videos:

Setting up the Linksys RE9000 to Range Extender mode (VIDEO)
Setting up the Linksys RE9000 to Access Point mode (VIDEO)
Getting to know the Linksys RE9000 Range Extender (VIDEO)

Was this support article useful?

Additional Support Questions?
Search Again